[ale] goofy printing problem

[lfs at eskimo.com (Andrew Newton)]

I don't have it all in my inetd.conf file because it isn't
started by inetd.  It is listed in my services file as:
printer		515/tcp		spooler		# BSD lpd(8)

Check your messages file (or whatever is setup to receive
syslog messages) and see what it says.  Perhaps that can clue
you into the problem.

Josh Murrah wrote:
> 
> OK, here's what I think has been my problem the whole time.  lpd quits
> about 2 seconds after it starts.  Is there something I need to setup in
> the services or inetd.conf file?  there's a port 'printer' in services,
> but there's no mention of port 151/UDP in the inetd.conf file.  Can
> someone cut & paste the pertaining lines in services and inetd.conf to me?
> I think that lpd doesn't have permissions to use it's port, because it's
> quitting right after I start it.
> 
> Thanks again.
> 
> Joshua Murrah, jmurrah at salug.org, http://www.salug.org/~jmurrah

-- 
Andrew Newton
lfs at eskimo.com
alnewton at automatedlogic.com
http://www.eskimo.com/~lfs