[ale] Sparc10

[ChrisF at computone.com (Chris Fowler)]

Here is what I have done
ok probe-scsi
Target 1
?? Unit 0???? Disk???????? QUANTUM P105SS 910-10-94A.1 08/31/89005090092
?????????????????????????????????????? GENERIC


ok probe-scsi-all
/iommu at f,e0000000/sbus at f,e0001000/espdma at f,400000/esp at f,800000
Target 1
?? Unit 0???? Disk???????? QUANTUM P105SS 910-10-94A.1 08/31/89005090092
?????????????????????????????????????? GENERIC



ok boot /iommu at f,e0000000/sbus at f,e0001000/espdma at f,400000/esp at f,800000
Boot device: /iommu at f,e0000000/sbus at f,e0001000/espdma at f,400000/esp at f,800000?? File and args:


Boot load failed


ok


-----Original Message-----
From: Jon Uhler [mailto:juhler at eoncc.com]
To: ale at ale.org
Sent: Monday, April 09, 2001 11:45 AM
To: 'Chris Fowler'
Subject: RE: [ale] Sparc10



Chris,
??
You need to do a stop a or a break during boot to get to the boot prompt (ok>) then change boot device.....
-----Original Message-----
From: Chris Fowler [mailto:ChrisF at computone.com]
To: ale at ale.org
Sent: Monday, April 09, 2001 11:34 AM
To: 'ale at ale.org'
Subject: [ale] Sparc10



I have a sparc10 I want to run Linux on.?? I need to load Linux on the unit and the unit tries to boot from Ethernet.?? How can I disable that?

I keep getting the following error message: 



Timeout waiting for ARP/RARP packet 
I can use arp to provide an address, but I need to boot from the hdd to see if Solaris is loaded.?? Hoe do I tell the system to boot from the drive not Ethernet.?? I'm not using video, I'm using serial console.

Chris