[no subject]

> I am having some major stability problems after building the new system 
> and was looking to cover all the bases.

If you think this is SCSI drive related (any error message?)
look at the following:

	- Check for correct SCSI bus termination (both sides)
	- Card should supply termination power
	- Ancient cables and high transfer speeds do not mix.
          ( Change cables or set reduced transfer speeds)
	- Check for correct SCSI bus termination (both sides)
	- Tagged queuing and old drives can be a problem.
          (disable tagged queuing or update drive firmware) 
	- Check for correct SCSI bus termination (both sides)

good luck

	Stephan

PS: Did I tell you to check the SCSI bus termination ? ;-)


</pre>
<!--X-Body-of-Message-End-->
<!--X-MsgBody-End-->
<!--X-Follow-Ups-->
<hr>
<ul><li><strong>Follow-Ups</strong>:
<ul>
<li><strong><a name="00453" href="msg00453.html">[ale] Adaptec 2940UW bios updates</a></strong>
<ul><li><em>From:</em> bluejay at speedfactory.net (Jim Seymour)</li></ul></li>
<li><strong><a name="00480" href="msg00480.html">[ale] Adaptec 2940UW bios updates</a></strong>
<ul><li><em>From:</em> bluejay at speedfactory.net (Jim Seymour)</li></ul></li>
</ul></li></ul>
<!--X-Follow-Ups-End-->
<!--X-References-->
<ul><li><strong>References</strong>:
<ul>
<li><strong><a name="00433" href="msg00433.html">[ale] Adaptec 2940UW bios updates</a></strong>
<ul><li><em>From:</em> bluejay at speedfactory.net (Jim Seymour)</li></ul></li>
</ul></li></ul>
<!--X-References-End-->
<!--X-BotPNI-->
<ul>
<li>Prev by Date:
<strong><a href="msg00439.html">[ale] zombie pc parts apology and good bye</a></strong>
</li>
<li>Next by Date:
<strong><a href="msg00441.html">[ale] Linux/Nt compatible large file systems</a></strong>
</li>
<li>Previous by thread:
<strong><a href="msg00433.html">[ale] Adaptec 2940UW bios updates</a></strong>
</li>
<li>Next by thread:
<strong><a href="msg00453.html">[ale] Adaptec 2940UW bios updates</a></strong>
</li>
<li>Index(es):
<ul>
<li><a href="maillist.html#00440"><strong>Date</strong></a></li>
<li><a href="threads.html#00440"><strong>Thread</strong></a></li>
</ul>
</li>
</ul>

<!--X-BotPNI-End-->
<!--X-User-Footer-->
<!--X-User-Footer-End-->
</body>
</html>