[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
BGP from Juniper to Cisco ASR
- Subject: BGP from Juniper to Cisco ASR
- From: elouie at yahoo.com (Eric A Louie)
- Date: Wed, 18 Dec 2013 17:01:25 -0800 (PST)
- In-reply-to: <[email protected]>
- References: <[email protected]>
When I had that problem, it was because the max-prefixes on the Juniper router was being triggered.?? If I remember correctly.? It's a strange return message for the wrong issue.
>________________________________
> From: Philip Lavine <source_route at yahoo.com>
>To: NANOG list <nanog at nanog.org>
>Sent: Wednesday, December 18, 2013 7:48 AM
>Subject: BGP from Juniper to Cisco ASR
>
>
>Dec 18 07:46:33: %BGP-3-NOTIFICATION: received from neighbor?<REMOTE PEER> active 2/5 (authentication failure) 0 bytes
>Dec 18 15:46:33.615: BGP: ses global?<REMOTE PEER> (0x7FB1CD209CF0:0) act Receive NOTIFICATION 2/5 (authentication failure) 0 bytes
>
>Although I have seem this on the message boards I am little confused in that the ISP is telling me that there is no authentication enabled on the Juniper and I do not have authentication enabled on the ASR. So what is going on here?
>
>
>
>