[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
BGP from Juniper to Cisco ASR
- Subject: BGP from Juniper to Cisco ASR
- From: EDugas at zerofail.com (Eric Dugas)
- Date: Wed, 18 Dec 2013 16:09:31 +0000
- In-reply-to: <[email protected]>
- References: <[email protected]>
Probably a TTL problem. Did you configure ebgp-multihop?
Eric Dugas
ZEROFAIL / AS40191
edugas at zerofail.com
-----Original Message-----
From: Philip Lavine [mailto:source_route at yahoo.com]
Sent: December 18, 2013 10:48 AM
To: NANOG list
Subject: BGP from Juniper to Cisco ASR
Dec 18 07:46:33: %BGP-3-NOTIFICATION: received from neighbor?<REMOTE PEER> active 2/5 (authentication failure) 0 bytes Dec 18 15:46:33.615: BGP: ses global?<REMOTE PEER> (0x7FB1CD209CF0:0) act Receive NOTIFICATION 2/5 (authentication failure) 0 bytes
Although I have seem this on the message boards I am little confused in that the ISP is telling me that there is no authentication enabled on the Juniper and I do not have authentication enabled on the ASR. So what is going on here?